- workshop7.jpg (212.43 KiB) Viewed 15744 times
The drill I found very cheap on e-bay, it came from the Smiths Clock Factory then spent 15 years in an all girls school before being bought by the guy I purchased it from. It works like new and is so accurate I managed to drill out a boot from a small clock lever, put a new brass stud in it and rivet it back to the lever. The hole was 0.3mm!
- workshop6.jpg (205.43 KiB) Viewed 15744 times
This brightly coloured vario-Lux lathe is a hobby lathe, I bought it as it had the milling attachment, great for general stuff but is hard work when you want something accurate.
- workshop5.jpg (243.25 KiB) Viewed 15744 times
These clocks are mainly mine, either to be used for parts or (when I have a bit of spare time
) are to be restored.
- workshop4.jpg (255.62 KiB) Viewed 15744 times
This last pic is of a Holbrook lathe, as soon as I have some other old lathes sold and out of the way it will be getting a new cabinet and a complete strip-down and clean. This is one heavy beast and took 3 people to drag it up the stairs, I will be borrowing my brothers engine crane to get it up on a cabinet. I hope I never have to move!