Minature End Mills
Moderators: willofiam, Bob Tascione
1 post
• Page 1 of 1
Minature End Mills
by david pierce » Sat Oct 26, 2013 7:53 pm
A company called Harvey Tool makes minature end mill cutters. They make them standard down to .001 inches in diameter. The ones I looked at had 1/8 of and inch diameter shanks.
- david pierce
- Posts: 1356
- Joined: Tue May 31, 2011 11:09 am
- Location: Stone Mountain, Ga
1 post
• Page 1 of 1
Return to Parts & Tool Suppliers & Other Helpful Resources
Who is online
Users browsing this forum: No registered users and 2 guests