Reamer and bushings
Posted:
Fri Feb 05, 2021 6:36 am
by Clock King
Hello everyone,
I’m looking the buy a reamer and bushings but I’m not sure what to get. There are so many sizes, what is the best sizes to start with?
Re: Reamer and bushings
Posted:
Fri Feb 05, 2021 8:59 pm
by Clocks-R-Me
Hello Clock King!
That’s a really good question. Fortunately it’s been covered in great detail
Up here over the years. I’ll post some links to some worth reading past discussions
that might help. The first link is a discussion that I was involved in. I posted some
links in a post that will also take you to some good pages. Hope I put the links in correctly.
https://clockrepairtips.com/forum/viewt ... ngs#p16971https://clockrepairtips.com/forum/viewt ... zes#p16822https://clockrepairtips.com/forum/viewt ... hing+sizeshttps://clockrepairtips.com/forum/viewt ... ngs#p17031Let us know if this is what you were asking about Clock King.
Dan
Re: Reamer and bushings
Posted:
Fri Mar 05, 2021 4:03 pm
by Clock King
Hi again everyone,
I bought a hand reamer and pivot gauge, but now I'm not sure of the best way to measure the plate height. What is best way to measure the height to follow the pivot gauge? I bought a micrometer but I'm too stupid to read it
Re: Reamer and bushings
Posted:
Sat Mar 06, 2021 8:05 am
by bluerich
Get a digital micrometer, online or at Harbor Freight store. Not expensive and easy to read.
Re: Reamer and bushings
Posted:
Sun Mar 07, 2021 6:04 pm
by Clock King
I bought a digital caliber, will that work?
Re: Reamer and bushings
Posted:
Tue Mar 09, 2021 2:32 pm
by JHargrove77
It'll work just fine for what you need.