Tascione

I'm sure a lot of you have run across this issue. I recently bought a Peerless 8mm lathe off e-bay and it arrived with the tailstock knob broken. I knew this before hand, so no big deal. Now I'm one of those geeky guys that's into anything techie, so not only do I work on clocks and watches, I also dabble in 3D printing. Here is my attempt to replace the broken knob. Turned out pretty good. I would be happy to supply the print file to anyone interested.

tailstock1.jpg (303.58 KiB) Viewed 2260 times

tailstock2.jpg (198.97 KiB) Viewed 2260 times

tailstock3.jpg (199.47 KiB) Viewed 2260 times

tailstock4.jpg (264.06 KiB) Viewed 2260 times

Just wanted to say "good job" !!!

It's great that you have that skill


Best regards

Randy