Thanks for the kind words.
Yes...I have a large grin on my face !
It was just a broken movement, no case.
I figured that somewhere along the line, the case was scrapped for gold,. like so many these days.
.
I would not have relegated it to this project if I had the case,..oh well.
The dial is from Otto Frei. It's for a 6497-2 config. I had to move the posts.
I used epoxy to reset them, as I don't have the proper dial tool.
The hands were also from Bob Frei ( they are actually 12s hands). The minute hand hole was a perfect fit, the hour hand pipe I closed a bit my my staking set.
A little trimming for length and they worked.
The case was something that eluded me for quite some time.
I didn't have the deep pockets for someone to do a production run for me.
Finally, I asked Helenrou ( in Hong Kong ) if they had ever considered building a case for the Hamilton conversions, and they said yes.
In fact, they were in the midst of production.
So a few months later, they came available.
Not too bad a fit w/ their movement ring ( fits a 912 or 921 ) , but I had to reduce the inside diameter a bit .
Thanks again for the input !
Best regards,
Randy