The clock is clean and oiled. The problem is that it isn't counting the chime correctly 1 through 12. It is repeating the same # more that once or short counting. I have found that the locking leaver is being dropped on the point of the rack for the first strike and then falls into the notch for all the rest of the steps and that is changing the count. Problem is that it is only happening on say 1-6 and then it is fine for the rest of the rack. I turned the snail 1 tooth forward and now it is landing on the point for strikes 7-13 ! I want to bend the rack tail to let the rack fall a little more or less so that the locking leaver will fall the bottom of the notch and not hit on the top, but that would seam to then just move the problem to the other end of the rack. Pivots seam tight on all of these parts. something is off on a curve or sweep that is causing it to change from one end to the other. Help please.
Dave